Your donations help keep this valuable resource free and growing. Thank you.
|
Wire Feed Welder Recommendations |
Post Reply | Page <1 345 |
Author | |
JGRANTAMX
AMC Addicted Joined: Jun/02/2017 Location: Maine Status: Offline Points: 1695 |
Post Options
Thanks(0)
|
When I started my restoration project a few years ago I figured a low cost welder would be all I need probably not going to get much use after I am done. I bought a Harbor Freight 170 AMP it was $159 on sale also bought a cart and two 60 cubic foot tanks I am setup for steel, silicone bronze and stainless, for the most part it works good the only issue I noticed is it starts like one of the older touch start welders and that can make for a sputter start, I learned right off to always start with a fresh angle cut wire and flow a little gas before welding otherwise not bad.
J
|
|
Post Reply | Page <1 345 |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |