|
|
|
Your donations help keep this valuable resource free and growing. Thank you.
|
rear quarter emblems on AMX removal |
Post Reply 
|
| Author | |
Gary Gray AMX 
AMC Apprentice 
Joined: Aug/20/2021 Location: WEEKI WACHEE, F Status: Offline Points: 95 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: rear quarter emblems on AMX removalPosted: Jan/16/2023 at 11:44am |
|
Can anyone tell me how to remove the rear qtr panel AMX emblem ?
The circle is what is difficult????? |
|
 |
|
|
tufcj
Supporter of TheAMCForum 
Supporter of TheAMCForum Joined: Jul/10/2007 Location: Watkins, CO Status: Offline Points: 4088 |
Post Options
Thanks(0)
Quote Reply
Posted: Jan/16/2023 at 11:53am |
|
There are just 3 push in retainer clips/pins. I've found it's easiest to remove the sail panel trim on the interior and push them out rather than risk breaking the pins. Bob tufcj
|
|
|
69 AMX
74 Javelin AMX 67 Rogue If you need a tool and don't buy it... you'll eventually pay for it... and not have it. Henry Ford |
|
|
|
|
mmaher94087
AMC Addicted 
Joined: Apr/01/2008 Location: Arizona Status: Offline Points: 1690 |
Post Options
Thanks(0)
Quote Reply
Posted: Jan/16/2023 at 12:02pm |
|
If they are held on with barrel clips (99.9% are) then carefully pry them off. There are three pins holding the quarter circles on. The other .5% that I've disassembled had sheet metal push-on nuts on the inside that were only accessible after the interior sail panels were removed.
|
|
|
Mike
|
|
|
|
|
Gary Gray AMX
AMC Apprentice
Joined: Aug/20/2021 Location: WEEKI WACHEE, F Status: Offline Points: 95 |
Post Options
Thanks(0)
Quote Reply
Posted: Jan/16/2023 at 12:59pm |
|
thanks, That's what I thought - the key is the inside sail panel.
Thanks again Gary
|
|
|
Gary
|
|
|
|
|
amxroc
AMC Apprentice
Joined: Apr/28/2019 Location: Pa Status: Offline Points: 32 |
Post Options
Thanks(0)
Quote Reply
Posted: Sep/13/2023 at 12:19pm |
|
You can reach them through the trunk but most times you can just get you fingers under them and wiggle them off. I would slide some painters tape under the circle at every possible angle and maybe use a small plastic pry tool.
|
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Click for TheAMCForum Rules
Topic Options