Your donations help keep this valuable resource free and growing. Thank you.
|
Engine to 727trans maximum misalignment |
Post Reply | Page <12 |
Author | |
Coloradoamx
AMC Addicted Joined: Jul/02/2007 Location: Parker, CO Status: Offline Points: 583 |
Post Options
Thanks(0)
|
Offset Dowel Pins are available for AMC in .007, -014, .021
|
|
Trader
AMC Addicted Joined: May/15/2018 Location: Ontario Status: Offline Points: 6916 |
Post Options
Thanks(0)
|
Nice find.
Also most AMC's I have found are offset vertically. It's easier to fix this with one straight dowel and one offset. There will be a minor angle offset doing this, but if you switch the offset dowel from one side to the other you can usually find the best position and get it within 0.002" which is fine for any street engine, PO.
|
|
Coloradoamx
AMC Addicted Joined: Jul/02/2007 Location: Parker, CO Status: Offline Points: 583 |
Post Options
Thanks(0)
|
It becomes more of an issue if the block has been line bored in the past. Especially troublesome with the newer manual transmissions.
|
|
Post Reply | Page <12 |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |