TheAMCForum.com Homepage
Forum Home Forum Home > The Garage > Transmission & Drivetrain
  New Posts New Posts RSS Feed - Engine to 727trans maximum misalignment
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Click for TheAMCForum Rules / Click for PDF version of Forum Rules
Your donations help keep this valuable resource free and growing. Thank you.

Engine to 727trans maximum misalignment

 Post Reply Post Reply Page  <12
Author
Message
Coloradoamx View Drop Down
AMC Addicted
AMC Addicted


Joined: Jul/02/2007
Location: Parker, CO
Status: Offline
Points: 582
Post Options Post Options   Thanks (0) Thanks(0)   Quote Coloradoamx Quote  Post ReplyReply Direct Link To This Post Posted: Aug/06/2022 at 12:31pm
Offset Dowel Pins are available for AMC in .007, -014, .021
Back to Top
Trader View Drop Down
AMC Addicted
AMC Addicted


Joined: May/15/2018
Location: Ontario
Status: Offline
Points: 6761
Post Options Post Options   Thanks (0) Thanks(0)   Quote Trader Quote  Post ReplyReply Direct Link To This Post Posted: Aug/06/2022 at 1:28pm
Nice find.
Also most AMC's I have found are offset vertically. It's easier to fix this with one straight dowel and one offset. There will be a minor angle offset doing this, but if you switch the offset dowel from one side to the other you can usually find the best position and get it within 0.002" which is fine for any street engine, PO.
Back to Top
Coloradoamx View Drop Down
AMC Addicted
AMC Addicted


Joined: Jul/02/2007
Location: Parker, CO
Status: Offline
Points: 582
Post Options Post Options   Thanks (0) Thanks(0)   Quote Coloradoamx Quote  Post ReplyReply Direct Link To This Post Posted: Aug/06/2022 at 3:31pm
It becomes more of an issue if the block has been line bored in the past.  Especially troublesome with the newer manual transmissions.
Back to Top
 Post Reply Post Reply Page  <12
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.03
Copyright ©2001-2019 Web Wiz Ltd.

This page was generated in 1.266 seconds.
All content of this site Copyright © 2018 TheAMCForum unless otherwise noted, all rights reserved.
PROBLEMS LOGGING IN or REGISTERING:
If you have problems logging in or registering, then please contact a Moderator or