Forum Home Forum Home > The Garage > Electrical - non engine
  New Posts New Posts RSS Feed - Electric Wiper Switch Replacement
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Click for TheAMCForum Rules / Click for PDF version of Forum Rules
Your donations help keep this valuable resource free and growing. Thank you.

Electric Wiper Switch Replacement

 Post Reply Post Reply Page  <12
billd View Drop Down
Moderator Group
Moderator Group

Forum Administrator

Joined: Jun/27/2007
Location: Iowa
Status: Offline
Points: 30803
Post Options Post Options   Thanks (0) Thanks(0)   Quote billd Quote  Post ReplyReply Direct Link To This Post Posted: Jan/19/2022 at 3:34pm
Originally posted by Nardo Nardo wrote:

Originally posted by Trader Trader wrote:

Have a look:
Believe AMC and Ford used the same sources for wiper and light switches - theory that cannot be proven!

Hmmm, that is pretty interesting. I have a rebuildable AMC wiper motor and plate but I also have a second AMX with vacuum wipers I'd like to convert. For this car I'm not stuck on originality and I would not mind experimenting with a conversion like this. Electric wipers have been one of the harder group of parts to put together. 

There was also a comment about 69 having a two speed switch. My switch is actually from a 70, as is the dash I'm using as a base for my custom dash install. Is that 2 speed or variable? If I have to, I think I can salvage the switch, I'll just have to figure out how to extend the broken shaft. 

AMC and Ford shared wiper switches and motors only 1973 and later. Prior to that, Prestolite supplied the entire wiper system including motor, mounting plate and wiring harness. 
The motor is a unique compound wound motor up through 1972. 
After that, Motorcraft supplied permanent magnet wiper motors (in the early 60s Ford used Prestolite wiper motors as well, single speed. I have one of those motors from a 62 I believe. Model number prefix is EPW)
The speed of the Prestolite motor is controlled by inserting resistance into the shunt field winding to reduce current through the shunt and increase speed. I know that sounds counter-intuitive but a series wound DC motor will run away. The shunt, or parallel field slows it down and controls speed. 
More power to the shunt field winding, less speed, less power to the shunt, more speed. 
So the switches up through 1972 have a resistor. For high speed the shunt is powered through the resistor. For low speed, they feed the shunt directly to slow it down. Some cars from AMC got 3 speed wipers - the motors are basically the same, the SWITCH is different. It will have two resistors hanging off the back. Low, medium, high speeds. Low goes through higher resistance (both resistors) medium goes through one resistor, high is direct, no resistor. 
You cannot use a Motorcraft switch or mist control on a Prestolite wiper motor.
Back to Top
 Post Reply Post Reply Page  <12
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.03
Copyright ©2001-2019 Web Wiz Ltd.

This page was generated in 0.066 seconds.
All content of this site Copyright © 2018 TheAMCForum unless otherwise noted, all rights reserved.
If you have problems logging in or registering, then please contact a Moderator or