Your donations help keep this valuable resource free and growing. Thank you.
|
70 Z bar install |
Post Reply |
Author | |
70amxvegas
AMC Addicted Joined: Apr/26/2009 Location: Lost Wages Status: Offline Points: 1793 |
Post Options
Thanks(0)
Posted: Feb/25/2021 at 9:29pm |
Can i remove or install the z bar without removing the mounting bracket bolted to the bell housing . Any tricks or tips.
Edited by 70amxvegas - Feb/25/2021 at 9:38pm |
|
troutwilly
AMC Addicted Joined: Sep/14/2007 Location: Carriere, MS Status: Offline Points: 992 |
Post Options
Thanks(0)
|
The only thing I can think of would be to remove the 2 engine mount to frame nuts on the driver's side and see if you can tilt the engine up enough. But that seems like a lot more trouble than removing the bell housing bracket and might cause other issues. Why do you not want to remove the bell housing bracket?
|
|
Bill O.
70 AMX |
|
70amxvegas
AMC Addicted Joined: Apr/26/2009 Location: Lost Wages Status: Offline Points: 1793 |
Post Options
Thanks(0)
|
Installing new headers and was trying mount the bracket to bell housing so once headers are in i can install the z bar without trying to mount that bracket with headers in . Very tight then
|
|
Trader
AMC Addicted Joined: May/15/2018 Location: Ontario Status: Offline Points: 6882 |
Post Options
Thanks(0)
|
So know one has responded, I'll provide experience from one installation.
1. hate headers! 2. unbolt the Z-bar bracket from the bell and stove wire everything up to the master cylinder , booster bracket ... 3. install the headers and gasket if used, with 4 long bolts loosely in place to locate the headers 4. re-attach the Z-bar 5 install the header The loosely attached header should give you the room to install the Z-bar.
|
|
70amxvegas
AMC Addicted Joined: Apr/26/2009 Location: Lost Wages Status: Offline Points: 1793 |
Post Options
Thanks(0)
|
Cool thanks
|
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |