TheAMCForum.com Homepage
Forum Home Forum Home > The Garage > AMC V8 Engine Repair and Modifications
  New Posts New Posts RSS Feed - Type I, Type II and Group 19 camshaft
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Click for TheAMCForum Rules / Click for PDF version of Forum Rules
Your donations help keep this valuable resource free and growing. Thank you.

Type I, Type II and Group 19 camshaft

 Post Reply Post Reply Page  <1 234
Author
Message
Trader View Drop Down
AMC Addicted
AMC Addicted


Joined: May/15/2018
Location: Ontario
Status: Offline
Points: 2461
Post Options Post Options   Thanks (0) Thanks(0)   Quote Trader Quote  Post ReplyReply Direct Link To This Post Posted: Aug/01/2020 at 2:07pm
That's "visual" of cylinder #2 intake and exhaust. Just trying to show how tightly packed the lobes are.
Between those machine squares with the cam in v-blocks is approximately 1.418" and the lobe small diameter is 1.392".
 Never seen an AMC cam like it, or any V8 cam for that matter.

Should add, that measuring with a dial indicator the intake and exhaust open and close as per the "cam card" posted within a degree and @0.050" I get 262 degrees intake and exhaust.

I don't have a 1" travel dial indicator or a lathe large enough to hold the cam, so cannot provide more exact numbers.



Edited by Trader - Aug/01/2020 at 9:45pm
Back to Top
 Post Reply Post Reply Page  <1 234
  Share Topic   

Forum Jump Forum Permissions View Drop Down



This page was generated in 0.090 seconds.
All content of this site Copyright © 2018 TheAMCForum unless otherwise noted, all rights reserved.
PROBLEMS LOGGING IN or REGISTERING:
If you have problems logging in or registering, then please contact a Moderator or