I'm trying to see about making new pivot arms from steel, to replace the factory cast arm. I don't have access to stamping, or spring making equipment, so the plan is to disassemble existing releases, and replace the arm only. The fewer new parts made, the cheaper it can be done, also. That being said, does anyone have some broken Pacer releases they've been saving?

This idea is still in its infancy, so I'm also trying to gauge interest, and figure out what the cost might be. If you're interested, or have some suggestions, I'm all ears.

Admins, feel free to move this, if it's not in the proper category.

Alex