Print Page | Close Window

1980 jeep j20

Printed From: TheAMCForum.com
Category: The Garage
Forum Name: AMC V8 Engine Repair and Modifications
Forum Description: AMC-made V8 engine mechanical, ignition and fuel from basic repair to high-perf modifications
URL: https://theamcforum.com/forum/forum_posts.asp?TID=14159
Printed Date: Mar/28/2024 at 8:06am
Software Version: Web Wiz Forums 12.03 - http://www.webwizforums.com


Topic: 1980 jeep j20
Posted By: fury933
Subject: 1980 jeep j20
Date Posted: Oct/27/2009 at 6:44pm
i have recently aquired a 1980 jeep j20 with the motorcraft 2300 on the top it has been modded out with a electric fuel pump and has been sitting  for five years i've pretty much changed everything out and cleaned everything possible but no matter what i do it ALWAYS FLOODS out under any load if your downhill its great or flatland its ok but ANY hill she boggs down and will not go until you downshift continuesly any help would be appreciated. i have adjusted the screws to the manufactures recomendations of 2 turns out and that seems pretty good but just wont stop flooding out.. i've cleaned the carb from top to bottom jets and all please helllp!!!!!

-------------
it its not safe sane or consencual its mutalation



Replies:
Posted By: hurst390sc
Date Posted: Oct/27/2009 at 7:41pm
How much fuel pressure do you have? Are you using a pressure regulator with the electric pump? Check all your filters also..

-------------
70'amx 390 4 spd.

69'sc rambler 390 4spd.



Posted By: fury933
Date Posted: Oct/27/2009 at 8:17pm
filters are new. according to previous owner it ran fine when he parked it so not thinking pressure is the issue since he installed it and drove it that way for years. i did get strangely curious and turn in the screws ridiculously close to half turns on both sides amazingly this helped tremendously.. but I've never run across something that runs on just half turn out.. will check pressure in A.M. also another note i did adjust the choke not that it really matters in this issue.. didnt really change anything. also fuel has been swapped out since what was in tank was 5 yrs old..

-------------
it its not safe sane or consencual its mutalation


Posted By: rixcj
Date Posted: Oct/28/2009 at 6:12am
I have a Holley 600 on a jeep with a 360. I set the mixture screws while using a vacuum gauge, and I get the best readings at 1/2 turn out, also.  It runs fine this way, so, I just leave it.
 
Rich


-------------
'79 cj5/401/ t-18/dana20/Holley TA 670/HEI/PS/PB/glass body/lots more to come...


Posted By: PHAT69AMX
Date Posted: Oct/28/2009 at 3:16pm
Gasket between top plate and main body seals fuel bowl from venturis.
Gasket seal area on the casting is a little narrow between them.
iirc the air cleaner stud also clamps the top plate to the main body
Just a possibility, on uphill, gas from fuel bowl leaking past gasket into venturis ?
or possibly sloshing out the bowl vents ?
Entire fuel bowl cavity is covered by a solid gasket sheet on the bowl side.
Maybe try setting the float a little lower than the stock spec ?
On one, the small hole cutout in the gasket did not "match" the top float tang
and prevented the float from traveling completely up and closing the needle.
Little gasket trimming with an exacto helped on that one.


-------------


Link to a http://www.youtube.com/watch?v=MySiKQsmWxU" rel="nofollow - Short YouTube Burnout Video



Posted By: fury933
Date Posted: Oct/29/2009 at 8:12am
well pressure is at a whooping 7 pounds and from what i read thats just one pound off from perfect for this application. float has been reset and checked with pump running it functions the way it should gaskets are all new now. its now snowing and at a beautiful 13 degree's so i'm waiting for another warm day to do more testings and tuning will try backin down screws a tad more to see what it does

-------------
it its not safe sane or consencual its mutalation


Posted By: fury933
Date Posted: Oct/30/2009 at 1:42pm
ok she runs excellent now with new adjustments and took a test run in daylight which is seldom, and notice under load i burn enough oil to elude any followers... so it still bogs down under load but is due to plugs oiling up BAD AHHH where to go from here...

-------------
it its not safe sane or consencual its mutalation


Posted By: tsanchez
Date Posted: Oct/30/2009 at 2:26pm
Is the choke open when it gets warm? Sound like its partially closed

-------------
http://s192.photobucket.com/user/antonsan/media/jav1_zps87a70dce.jpg.html" rel="nofollow">


Posted By: fury933
Date Posted: Oct/30/2009 at 2:39pm
choke is open when warm she's burning oil like no tomorrow actually got pulled over today for it lol so its pretty bad. thinking maybe the guides?

-------------
it its not safe sane or consencual its mutalation



Print Page | Close Window

Forum Software by Web Wiz Forums® version 12.03 - http://www.webwizforums.com
Copyright ©2001-2019 Web Wiz Ltd. - https://www.webwiz.net