![]() |
Your donations help keep this valuable resource free and growing. Thank you.
|
74 Javelin intermittent gauges |
Post Reply ![]() |
Author | ||
MartyB ![]() AMC Apprentice ![]() ![]() Joined: Apr/24/2018 Location: Plano, TX Status: Offline Points: 37 |
![]() ![]() ![]() ![]() ![]() Posted: Feb/13/2019 at 4:59pm |
|
Car has been sitting for a while w elec issues. It is a 401 w Go Pak gauges. Got everything working (fuel, temp, oil press, tach)...but they will work intermittently then go to zero or max out (the tach just goes to 0). Sounds like a ground issue to me but I was careful to make sure the ground wire in the gauge plug was good (and tach is a separate ground)...and the dash gauge lights are working. Next issue...the 74 year only rheostat dimmer switch for the panel was broken so it was replaced w one of the earlier year switches. Seemed simple enough as the connector just plugged into it. Now I notice that w the headlight sw off and the panel light sw off the lights for the lower dash are on (even w ign sw in off posn). When the hl sw is on, the gauge lights are on, but dim. If the panel light sw is set to dome (w hl sw on), the dome light is on and the gauge lights are bright!
|
||
![]() |
||
304-dude ![]() AMC Addicted ![]() ![]() Joined: Sep/29/2008 Location: Central Illinoi Status: Offline Points: 9082 |
![]() ![]() ![]() ![]() ![]() |
|
For the gauges, it could be the IVR, you will need to pull the clister to test. While your at it, make sure the noise supressor is seated well on the pins. And check every pin for any loosness. None should wiggle.
Clean with pencil eraser being gentle not to cause bending or stress to the pins. As for lights being on when switches are off. Disconnect head light switch and remove for ohming the connections. You may have a shorted out internally switch. |
||
71 Javelin SST body
390 69 crank, 70 block & heads NASCAR SB2 rods & pistons 78 Jeep TH400 w/ 2.76 Low 50/50 Ford-AMC Suspension 79 F150 rear & 8.8 axles Ford Racing 3.25 gears & 9" /w Detroit locker |
||
![]() |
||
Mopar_guy ![]() Supporter of TheAMCForum ![]() ![]() Joined: Jun/07/2009 Location: Ohio Status: Offline Points: 4823 |
![]() ![]() ![]() ![]() ![]() |
|
He's right. The pins in that connector are a PITA. I have the same issue and when I get the car back out, I'm fixing that problem once and for all while I'm swapping out my tach.
|
||
![]() |
||
bigbad69 ![]() Supporter of TheAMCForum ![]() ![]() Joined: Jul/02/2007 Location: Ottawa, Ont. Status: Offline Points: 6668 |
![]() ![]() ![]() ![]() ![]() |
|
|
||
69 Javelin SST BBO 390 T10
|
||
![]() |
Post Reply ![]() |
|
Tweet
|
Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |