Your donations help keep this valuable resource free and growing. Thank you.
|
Bellhousing alignment. |
Post Reply | Page <12 |
Author | |
Javelin69
AMC Apprentice Joined: Dec/11/2013 Location: Madison wi Status: Offline Points: 187 |
Post Options
Thanks(0)
|
I'll check but I think it's 50 total.
|
|
Lyle
AMC Addicted Joined: Jul/17/2014 Location: None Status: Offline Points: 772 |
Post Options
Thanks(0)
|
If the shafts are parallel and concentric you can determine if the block or bell is wrong. For a long term solution it would be best to take the offending part, block or bell, machine oversize, press or thread sleeve and machine the holes in the correct location. Then you don't have to worry about custom step dowels, changing engines/transmissions/clutch or converter in the future. Your machine shop should be able to do this with little expense if they have already determined the offset.
|
|
Javelin69
AMC Apprentice Joined: Dec/11/2013 Location: Madison wi Status: Offline Points: 187 |
Post Options
Thanks(0)
|
It's being done in the auto shop at a tech school, so
I'm not sure they have the resources to do that. I also don't know what sort of shop to Inquire about a service like that. Edited by Javelin69 - Sep/25/2017 at 8:05am |
|
Post Reply | Page <12 |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |