oil thru pcv valve

I had to put the project on hold for the winter as I had to store the car 2 days ago but  before I did

I try a limited experiment that I tought You should know...

I liked the reversing the pcv flow ideas that were suggested and thought it'd be a good place to start so I took the pcv out of the intake (eddie air gap) and shoved it into the hose comming out of the stock oil fill cap,then I blocked the pcv hole in the intake ,i also stuck a large piece of stainless steel scouring pad

into the oil filler tube before putting the cap back on.keep in mind however that I'm running a Moroso pcv air oil seperator also.any how took it for a couple of high rpm runs on the way to storage and

on that one limited run I saw NO smoke out the exhaust at runs between 3500 and 5500 rpms .Hope this actually works in the long term !! A sincere thanks to all in the AMC forum who contributed to helping Me with this problem.I do have a sneaking suspicion that oil in the intake problem may only be temporarily

masked ...will update you all next spring.

Didn't get a pic of the entire pcv system before storing ,just have these(before I tried reversing the pcv flow-I'll take some one car is out in spring .

 

 Aparantly I have no idea how to post pictures on this -grrrr ...

  https://www.facebook.com/#!/photo.php?fbid=10152324442562611&set=a.10152224817197611.1073741828.674822610&=1&theater - https://www.facebook.com/#!/photo.php?fbid=10152324442562611&set=a.10152224817197611.1073741828.674822610&type=1&theater

 

 

 

https://www.facebook.com/#!/photo.php?fbid=10152324441032611&set=a.10152224817197611.1073741828.674822610&=1&theater - https://www.facebook.com/#!/photo.php?fbid=10152324441032611&set=a.10152224817197611.1073741828.674822610&type=1&theater

 

https://www.facebook.com/#!/photo.php?fbid=10152324441032611&set=a.10152224817197611.1073741828.674822610&=1&theater - https://www.facebook.com/#!/photo.php?fbid=10152324441032611&set=a.10152224817197611.1073741828.674822610&type=1&theater