|
|
|
Your donations help keep this valuable resource free and growing. Thank you.
|
Jeep CJ7 with AMC engine |
Post Reply 
|
Page <12 |
| Author | |
AZ_chip 
AMC Apprentice 
Joined: Jun/28/2014 Location: Arizona Status: Offline Points: 40 |
 Post Options
 Thanks(0)
 Quote Reply
 Posted: Jul/06/2014 at 12:19am |
|
Still looking for where all the hoses go. There is a black canister on the aft side of the left front panel. Is that the canister? This is like building a puzzle with no idea what the outcome should look like.
|
|
 |
|
|
carnuck
AMC Addicted 
Joined: Mar/31/2010 Location: Seattle Status: Offline Points: 3942 |
Post Options
Thanks(0)
Quote Reply
Posted: Jul/06/2014 at 8:46am |
|
It's like trying to make the picture puzzle of the rooster out of all those cornflakes!
|
|
|
Got an Eagle?
http://forums.amceaglesden.com |
|
|
|
|
Vezzzzzzz
AMC Apprentice
Joined: Jun/01/2014 Location: TX Status: Offline Points: 53 |
Post Options
Thanks(0)
Quote Reply
Posted: Jul/18/2014 at 7:22pm |
|
I had that same carb on my 304 for years. Its starts out ok but after about 20k miles it runs rich. Try leaning out the gas and adjusting the float in the bowl. lean it out till just right before it starts to die on you then back it back heavy again. Then adjust the float to compensate for the low gas fuel mix. Then adjust the idle up to about 800-1000 rpm. This will get you the same HP at idle as running heavy fuel at low idle or light fuel at a higher idle. Unless you have a stroked out motor or supercharger or something the 600 cfm is a little too much for anything less than the 401 in my opinion.
Worked for me. |
|
|
Jeffry
|
|
|
|
|
Post Reply
|
Page <12 |
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Click for TheAMCForum Rules
Topic Options