Your donations help keep this valuable resource free and growing. Thank you.
|
switch nut tool |
Post Reply |
Author | |
matty 401
AMC Addicted Joined: Jul/06/2007 Location: Iowa Status: Offline Points: 1730 |
Post Options
Thanks(0)
Posted: Aug/29/2017 at 4:21pm |
on the headlight ones i have used a blade screwdriver a lot
|
|
72 matador 401 the beast
79 concord 2 door 72 matador 304 grasshopper 68 Rogue 406 93 Cherokee 4.0 5 speed |
|
73Gremlin401
Supporter of TheAMCForum Joined: Mar/02/2013 Location: Stmbt Sprgs CO Status: Offline Points: 941 |
Post Options
Thanks(0)
|
Excellent solution. As one of the buyers of said $22 tool, yes, it does work, but only a couple of times. The teeth on it are very fragile, and on my 3rd junkyard trip to snag a few switches, a tooth broke off without much effort, and I was out of business.
so yes, using a hardened socket makes a bit more sense long term. |
|
73 Gremlin 401/5-spd.
77 Matador Wagon 360/727. 81 Jeep J10 LWB 360/4-spd 83 Concord DL 4-dr 258/auto |
|
billd
Moderator Group Forum Administrator Joined: Jun/27/2007 Location: Iowa Status: Offline Points: 30894 |
Post Options
Thanks(1)
|
having spent the last 47 years using everything from screwdrivers to needle-nose pliers, and even other odds and ends, to remove those deep slotted nuts that hold the wiper and headlight switch into the dash of our cars, I looked around for a proper tool.
Sorry to the eBay seller of such a tool, but really - 22 bucks? Really? It's a cylinder with a couple of narrow squared teeth spaced just right, and deep enough to straddle the switch shaft. Nothing more, nothing less. Hmmm........... I dug through my tool box and found the small box of broken or worn out sockets. Among them was a well-used 3/8" drive deep socket. I rigged a way to mount it solidly to the bed of my little mill and slowly cut the sides of the end of the socket away, leaving just enough to just fit into the dash nut slots. I cut the sides away far enough down so the teeth left sticking up would just bottom, but not too long, so the socket would be easy to square against the face of the nut. About 10 minutes and zero dollars later I had a dash switch nut socket that I could use a ratchet on if necessary, and that was still plated save for where I cut with the end cutter to form the teeth that fit into the nut's slots. I could still plate that end if I wished but why - unless I leave it laying somewhere it can get wet it shouldn't be a problem. I'll try to remember to get a picture later. So if you have a worn or even cracked deep socket, and a mill, or even a Dremel tool with a metal cutting wheel, you can make such a tool for far less than $22. |
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |