Floor Insulation Kit (heavy asphalt)

where is the black plastic piece that was under the scuff plate? that covers the cable and wiring.

some one closer to you may have the items. one for each side. thank you.

AV1956
  On my AMX's, the parking brake cable runs on top of the asphalt layer up to the kick up in the floor just in front of the front seat mounting brackets. It then goes thru a hole in the kick-up, with a very large plastic or hard rubber grommet. The aftermarket park brake cables have a large yellow grommet which will NOT fit into the factory hole in the floor, a little razor knife work and you can replace it with the original rubbery grommet. If you don't have an original grommet, a couple layers of rubber fuel line/heater hose type rubber will prevent water intrusion and rattling. From this point, the park brake cable goes under the body, IIRC it is attached to the body floor in several places with cable clamps on it's way to the left rear connection to the left/right rear axle brake cables.
  Not sure about the wiring bundle, but my best recollection is that it runs down the door hinge side under the kick panel trim down to the door sill trim. None of mine had any plastic under the sill trim, but there was a black paper isolator, similar to the door panel waterproofing sheet, between the door sill trim and the body sill with the wiring under that paper isolator. Good luck with your AMX.

Terry


Edited by TX390AMX - Oct/11/2019 at 9:27pm

thank you. i was basing it on the two gremlins where i took the scuff plates off.