TheAMCForum.com Homepage
Forum Home Forum Home > The Garage > AMC V8 Engine Repair and Modifications
  New Posts New Posts RSS Feed - early 90s crane roller lifter  wheel size?
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Click for TheAMCForum Rules / Click for PDF version of Forum Rules
Your donations help keep this valuable resource free and growing. Thank you.

early 90s crane roller lifter wheel size?

 Post Reply Post Reply
Author
Message
greendragon View Drop Down
AMC Apprentice
AMC Apprentice
Avatar

Joined: Feb/22/2016
Location: huntsville ala
Status: Offline
Points: 81
Post Options Post Options   Thanks (0) Thanks(0)   Quote greendragon Quote  Post ReplyReply Direct Link To This Post Topic: early 90s crane roller lifter wheel size?
    Posted: Nov/07/2019 at 3:01pm
my cam grinder wants to know what size my early-mid 90s crane roller "wheel" is..if its smaller  than .812 ?   trying to find out without taking the manifold off
moneypit
Back to Top
greendragon View Drop Down
AMC Apprentice
AMC Apprentice
Avatar

Joined: Feb/22/2016
Location: huntsville ala
Status: Offline
Points: 81
Post Options Post Options   Thanks (0) Thanks(0)   Quote greendragon Quote  Post ReplyReply Direct Link To This Post Posted: Nov/07/2019 at 3:25pm
I"m going to guess the .750 wheel in the early rollers?
moneypit
Back to Top
BassBoat View Drop Down
AMC Addicted
AMC Addicted


Joined: Aug/29/2008
Status: Offline
Points: 1075
Post Options Post Options   Thanks (0) Thanks(0)   Quote BassBoat Quote  Post ReplyReply Direct Link To This Post Posted: Nov/08/2019 at 11:09am
Crane 86518 (I have a couple used sets) are 0.750 These came out of an engine in 2006 so not sure if they were "early" or "late"
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down



This page was generated in 0.125 seconds.
All content of this site Copyright © 2018 TheAMCForum unless otherwise noted, all rights reserved.
PROBLEMS LOGGING IN or REGISTERING:
If you have problems logging in or registering, then please contact a Moderator or