Your donations help keep this valuable resource free and growing. Thank you.
|
401 Roller Motor Update |
Post Reply | Page <12 |
Author | |
SKeown
AMC Addicted Joined: Jul/30/2009 Location: Texas Status: Offline Points: 3085 |
Post Options
Thanks(0)
|
I used the same length with both Johnson and crane lifters, when using shaft rockers there's not much room for variation either.
SKeown
|
|
Ontario Automotive
AMC Fan Joined: Aug/02/2012 Location: callander on Status: Offline Points: 3 |
Post Options
Thanks(0)
|
we used crane pushrods and chevy big block roller lifters we straightened the strap out that holds the lifters together and they fit perfectly
|
|
Rebel Machine
AMC Addicted Joined: Jul/03/2007 Location: Western Il Status: Offline Points: 5122 |
Post Options
Thanks(0)
|
Lifter bores measure okay, about 0.905" with some around 0.9053". Machine shop phoned several places including Comp Cams. They said they make them 0.903" in diameter even though they advertise 0.904. They don't think the diameter is the problem. I'm going to order a flat tappet cam like the one that was in it so I can make Cordova. We'll figure out all this roller cam stuff later. -Steve- |
|
SKeown
AMC Addicted Joined: Jul/30/2009 Location: Texas Status: Offline Points: 3085 |
Post Options
Thanks(0)
|
"They don't think the diameter is the problem".
Could it be because their's are too small? I can tell you definitely that it matters. Bushed lifter bores incteased my oil pressure 10 psi across the board and eliminated the fluctuation too.
SKeown
|
|
Post Reply | Page <12 |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |